![]() ![]() It only shows the settings that are required to create the sensor. The Add Sensor dialog appears when you manually add a new sensor to a device. If you want to use this sensor, add it to a remote probe device. You cannot add this sensor to the hosted probe of a PRTG Hosted Monitor instance. See the Knowledge Base: How can I change the default groups and channels for flow and Packet Sniffer sensors?.See the Knowledge Base: What is the Active Flow Timeout in flow sensors?.This sensor supports the IPv6 protocol.You can only set it up on a local probe or a remote probe but not on a cluster probe. You cannot use this sensor in cluster mode.You can change the selected IP addresses in the sensor settings. If you add the clone to a different probe, PRTG selects all available IP addresses by default. If you add the clone to the same probe, PRTG keeps the selected IP addresses on which it listens for Flow (NetFlow, jFlow, sFlow, IPFIX) packets. For cloning this sensor, the following rules apply.The device must send the flow data stream to the IP address of the probe system. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |